Leather belt Duke & Skulls, red, 38 mm

Tailor-made for you personally with love, passion and skill!

✅ Handmade in Germany: My leather belts are made entirely by hand without the use of machines and are "Made in Germany" from my factory in Reichenbach adFils. They promise the highest quality and each one is unique. The patterns are carefully stamped into the leather individually using small stamps and a hammer, which creates a special depth effect that you can also feel! Depending on the type, all seams are hand-stitched with two needles, a piercing awl and high-strength waxed thread in a saddler's stitch! (This seam holds!)

✅ Leather: Particularly stable, low-tension and robust 100% vegetable-tanned full-grain leather from Italy, Germany or America, made from a piece of genuine cow or bull leather from the best part of the skin, the croupon, with a leather thickness of approx. 4.0 to 6.2 mm! (Depending on the model.) Very durable and designed to last for many years.

✅ Buckle: The high-strength buckles have a particularly high density, which makes them extremely resistant to impacts, abrasion and oxidation. Made of stainless steel, solid brass or high-strength die-cast zinc in different shapes, sizes and colors! These are screwed onto the leather straps in a high-quality manner to make it easy to change the buckle.

✅ Transparent: To make the quality of my belts visible, my models have open cut edges, depending on the design, or they have been manually deburred, sanded, polished and sealed. I don't hide my leather products behind a plastic edge and don't have to conceal anything!

✅ Unique & Stylish: Since the belts are handmade and extremely sturdy, they are unique, particularly durable and therefore sustainable. They complete your stylish look.

Put your belt on the table and use a tape measure or ruler to measure from the end of the buckle (see picture) to the hole you always wear (comfort hole). This is the waist size. "Optimal fit" in this sense means that your new belt is made so that the buckle pin lands in the middle of the 7 pin holes.

Important: I need your waist size, not the total length of the belt or information from third-party manufacturers!

Alternatively, measure your waist size with a flexible tape measure.
Put on a pair of well-fitting trousers/jeans and make sure that they sit correctly on your waist. Take a flexible tape measure and pull it through the belt loops. The result in cm corresponds to your waist size and therefore also the belt size you need. Don't have a flexible tape measure to hand? No problem - just take a piece of string and pull it through the belt loops. Mark the place where the string 'closes' and then measure the length using a ruler - and you have your waist size/belt size.

The measurement results must then be selected for your desired item in the "Waist size" section. Tap on the box with the desired measurement. If in doubt, always choose the next larger size; a longer belt always fits better and can be shortened depending on the model, unlike a belt that is too short. The hole spacing is 2.0-2.3 cm and 7 holes are used as standard.

If you need a measurement (waist size) for a belt that is not available or need help, please contact me. Note: I am not responsible for any measurement errors on your part.